APPLICATION NOTE
TELULAR SX5 SERIES PHONE CELL & XPERT2/9210B SPEECH MODEM (OR 8210-3014 MODEM)
2
2. EQUIPMENT & OPTIONS
The application requires the following equipment:
Part Number
Description
1
9210-0000-1A
9210 Datalogger
2
8080-0005-1
XPert Voice Modem
3
SX5X-XX
Phonecell SX5 series FWT with RJ-11, RJ11 cables, AC power cable
4
8210-3014-1A
8210 Data Logger with Speech Modem
PHONECELL
®
is a registered trade mark of the Telular Corporation.
The FWT is typically supplied with an eight (8) inch omni antenna. The antenna input connection of
the FWT is a TNC female connection. This antenna is suited for use in areas with strong cellular service
signal. The following antenna options are available:
8111-1168-1 Antenna, YAGI, 800MHz, 6db w/15ft RF cable
8111-1168-2 Antenna, ONMI, Dual Band 800-1900 MHz, 2db w/15ft RF cable
8111-1168-3 Antenna, YAGI, 1900MHz, 6db w/15ft RF cable
Each includes a coaxial surge protector and 3ft TNC male to type N male jumper cable to interface
from the type N female protector to the antenna.
3. EQUIPMENT CONNECTIONS
The equipment configuration consists of a 9210 Datalogger, an XPert Voice Modem, and a SX5 series
cellular FWT.
The XPert Voice Modem will be connected to Com3 of the 9210. A straight DB-9 modem cable should
be used. Com3 is configured to p5VDC power to the modem on pin 9. If Com2 is used, power
to the modem must be provided externally. The cellular modem transceiver will be connected to the
XPert Voice Modem using an RJ-11 connection. The cellular modem has an RJ-11 receptacle on its
side, connect a cable from this port to either of the RJ-11 receptacles of the Sutron XPert Voice
Modem.
Therefore, XLite 9210 connects to the XPert Voice Modem through a standard DB-9 modem cable. The
XPert Voice Modem connects to the SX5 FWT via a standard RJ-11 phone cable.
