TRIO MPC-145 SERIES MICROMANIPULATOR SYSTEM OPERATION MANUAL – REV. 2.62C (20191001) (FW V2.62)
26
Figure 3-13. Angled side view of MP-845 to change headstage mount
To change the headstage/micropipette, loosen the screw in the center of the rotary dovetail
clamp. Slide the headstage upward out of the dovetail groove. Make any adjustments needed
of the headstage, and then tighten down (but do not over tighten) the lock screw in the
center of the holding bracket.
Rotary dovetail holder
for rod/micropipette
holder or headstage
Rotary dovetail
clamp screw
Rotary dovetail angle
lock set screw