5. Press [Start Stop] when you reach the finish line to pause the
recording.
6. Press [Back Lap] to stop recording. After stopping the exercise,
save the log by pressing [Start Stop]. If you do not want to save
the log, press [Light Lock].
Scroll with [Next] through summary views, until you reach the
distance summary. Adjust the distance shown on the display to
the actual distance you ran with [Start Stop] and [Light Lock].
Confirm with [Next].
7. Confirm the POD calibration by pressing [Start Stop]. Your foot
POD has now been calibrated.
NOTE:
If the foot POD connection was unstable during the
calibration exercise, you might not be able to adjust the distance in
the distance summary. Make sure that foot POD is attached
properly according to instructions and try again.
If you are running without a foot POD, you can still get running
cadence from the your wrist. Running cadence measured from wrist
is used together with FusedSpeed and is always on for specific sport
modes including running, trail running, treadmill, orienteering, and
track and field.
If a foot POD is found at start of an exercise, running cadence
measured from wrist is overwritten by foot POD cadence.
96
Summary of Contents for AMBIT2 R 2.0
