Description of Function Codes NICE3000
new
User Manual
- 194 -
Group Fd: Communication Parameters
Function Code
Parameter Name
Setting Range
Default
Unit
Property
Fd-00
Baud rate
0: 9600
1: 38400
0
bit/s
★
Fd-02
Local address
0–127
0: Broadcast address
1
-
★
Fd-03
Communication
response delay
0–20
10
ms
★
Fd-04
Communication
timeout
0.0–60.0
0: Invalid
0.0
s
★
These RS232 serial port communication parameters are used for communication with the
monitor software in the host computer.
•
Fd-00 specifies the baud rate for serial communication. Fd-02 specifies the current
address of the controller. The setting of these two parameters must be consistent with
the setting of the serial port parameters on the host computer.
•
Fd-03 specifies the delay for the controller to send data by means of the serial port.
•
Fd-04 specifies the communication timeout time of the serial port. Transmission of each
frame must be completed within the time set in Fd-04; otherwise, a communication fault
occurs.
Function Code
Parameter Name
Setting Range
Default
Unit
Property
Fd-05
Re-leveling stop delay
0.00–2.00
0.00
s
★
It is used to set the stop delay at re-leveling. After receiving the leveling signal during re-
leveling, the elevator stops after the delay set in this parameter.
Function Code Parameter Name
Setting Range
Default Unit Property
Fd-07
HCB:JP1 input
0: Reserved
NO/NC input:
1/33: Elevator lock signal
2/34: Fire emergency signal
3/35: Current floor forbidden
4/36: VIP floor signal
5/37: Security floor signal
6/38: Door close button input
1
-
★
Fd-08
HCB:JP2 input
2
-
★
These parameters are used to set the functions of pins 2 and 3 of JP1 and JP2 on the HCB.
The setting is effective to the HCBs for all floors.
Summary of Contents for NICE3000 New
