Use of the NICE3000
new
NICE3000
new
User Manual
- 66 -
Chapter 4 Use of the NICE3000
new
The NICE3000
new
supports four commissioning tools, 3-button keypad on the MCB, LED
operation panel, LCD operator, and host computer monitoring software.
Tool
Function Description
Remark
Onboard 3-button keypad
It is used to enter the shaft commissioning
commands and view floor information.
Standard
LED operation panel
It is used to view and modify parameters related
to elevator drive and control.
Optional
LCD operator
It is used to view parameters related to elevator
drive and control in diagram and text, and modify
and copy these parameters.
Optional
Host computer monitoring
software
It is used to monitor the current elevator state,
view and modify all parameters, and upload and
download parameters on the PC.
Optional
The following part describes the commonly used keypad, LED operation panel, and LCD
operator in detail.
4.1 Use of the Onboard Keypad
The onboard keypad consists of three 7-segment LEDs and three buttons. You can view
information about the controller and enter simple commands on the keypad.
Note
The keypad is exposed, and pay attentions to the following points during use:
1. Wear insulated gloves when performing operations on the keypad to prevent electric shock or
damage to the controller components due to electrostatic discharge.
2. Do not use a metal or sharp tool to press the button to prevent the short-circuit fault or damage
to the components on the MCB.
The following figure shows the appearance of the keypad.
Figure 4-1 Appearance of the keypad
PRG
UP
SET
3
2
1
A
B
C
DP
D
E
F
G
As shown in the preceding figure, the three buttons are PRG, UP, and SET. The functions of
the three buttons are as follows:
•
PRG: Press this button in any state to display the current function group number.
You can press the UP button to change the function group number.
Summary of Contents for NICE3000 New
