Disassembly and Assembly
Technical Handbook
019722-101 Rev. 05
52
SC-350/360
8.14 Thickness Selector Unit - Removal
a) Remove the top cover, see
8.3 “Covers - Removal” on page 42
.
b) Raise the thickness guide block.
c) Set the thickness selector (1) in position 3.6 mm (max.)
d) Loosen the two screws (2) using a 2.5 mm Allen key.
e) Remove the knob (1).
f) Loosen the locking nut (3) and loosen the screw (4).
Note!
Beware of the two balls (5) and the spring (6) inside the unit.
g) Loosen the screw (7) using a 2 mm Allen key.
h) Lift off the insert (8) from the axle.
i) Remove the two screws (9) and lift off the unit.
