13
SECTION 4: MAINTENANCE
Vantage™ Cleaning and Maintenance
Note: Electrical power must be disconnected from the bill acceptor before performing any
cleaning operations
.
Recommended Cleaning Material
A mild solution of detergent can be used for cleaning the belts, bill path and sensor lenses, as well as
for general cleaning of the bill acceptor. Beverages or other water-soluble liquids which have been
spilled on or into the bill acceptor can usually be removed with warm soapy water. External surfaces
can be cleaned with a damp cloth.
Note:
Petroleum-based cleaners and freon-based propellants can damage plastic and some elec-
tronic components. Scouring pads and stiff brushes may harm circuit boards and can mar the plastic.
These items should never be used to clean the bill acceptor.
Cleaning the Vantage
The Vantage should be cleaned every 20,000 bills or every two years (or as needed, depending on
the environmental conditions of the location). Dust can be removed with a soft brush or cloth or it can
be blown out using compressed air.
Summary of Contents for Coinco Vantage Series
