Installation
SC 303/313
8
013447-101_rev-07
SCAN COIN
4
Installation
4.1
Installation Requirements
• The machine must be placed on a stable horizontal surface.
• Ensure that the environmental requirements are met when
installing the machine, see
6.2 “Environmental” on page 11
.
• Do not place the machine close to any radiators.
• Do not place the machine in direct sunlight as reflections from
the sunlight will make it impossible to read messages displayed
on the screen and may also cause the internal temperature of the
machine to rise above an acceptable level.
• Allow some free space around the machine to enable the air to
circulate.
WARNING
!
Risk of electric shock!
The machine is of metal construction and must therefore always be
earthed to the supply. Ensure that the plug on the supply lead is
earthed and that the supply source is earthed. This is a requirement
for this type of equipment and if not adhered to will contravene the
international standards of Health and Safety in the work place.
Although this machine has been tested for electromagnetic
compatibility and vibration characteristics, it is recommended that
no equipment which generates a high level of electromagnetic
interference (EMI) or vibration is placed close to this machine.
Note!
If the plug on the supply lead to the machine has a fuse, make sure it
has the correct rating in amps. Refer to
For AC voltage input, see section
Summary of Contents for SCAN COIN SC 303
