Engine General Information and Diagnosis: 1A-18
DTC Table
B931H21104006
In the LCD (DISPLAY) panel, the malfunction code is indicated from small code to large code.
*1
To get the proper signal from the throttle position sensor, the sensor basic position is indicated in the LCD (DISPLAY)
panel. The malfunction code is indicated in three difgits. In front of three digits, a line appears in any of the position,
upper, middle or lower line. If the indication is upper or lower line when engine rpm is 1 500 rpm, slightly turn the
throttle position sensor and bring the line to middle.
In the normal condition, the throttle valve stop screw pushes throttle valves slightly, and indication point is middle line.
Fail-Safe Function Table
B931H21104007
FI system is provided with fail-safe function to allow the engine to start and the vehicle to run in a minimum
performance necessary even under malfunction condition.
The engine can start and can run even if the above signal is not received from each sensor. But, the engine running
condition is not complete, providing only emergency help (by fail-safe circuit). In this case, it is necessary to bring the
vehicle to the workshop for complete repair.
Code
Malfunction Part
Remarks
C00
None
No defective part
C12 (P0335)
)
(Page 1A-23)
Crankshaft position sensor (CKP sensor)
Pick-up coil signal, signal generator
C13 (P0105-H/L)
)
(Page 1A-26)
Intake air pressure sensor (IAP sensor)
C14 (P0120-H/L)
)
(Page 1A-33)
Throttle position sensor (TP sensor)
*1
C15 (P0115-H/L)
)
(Page 1A-40)
Engine coolant temperature sensor (ECT
sensor)
C20 (P1752)
)
(Page 1A-45)
Differential lock relay (Diff-lock relay)
C21(P0110-H/L)
)
(Page 1A-47)
Intake air temperature sensor (IAT sensor)
C23 (P1651-H/L)
)
(Page 1A-52)
Tip-over sensor (TO sensor)
C24 (P0351)
)
(Page 1A-59)
Ignition signal (Ignition coil)
C32 (P0201)
)
(Page 1A-59)
Injector signal (FI)
C40 (P0505-H/L)
)
(Page 1A-59)
Idle speed control valve (ISC valve)
C41 (P0230-H/L)
)
(Page 1A-59)
Fuel pump control system (FP relay)
Fuel pump, Fuel pump relay
Item
Fail-Safe Mode
Starting Ability
Running Ability
IAP sensor
Intake air pressure is fixed to 101 kPa (760
mmHg).
“YES”
“YES”
TP sensor
The throttle opening is fixed to full open
position.
Ignition timing is also fixed.
“YES”
“YES”
ECT sensor
Engine coolant temperature value is fixed to
80
°
C (176
°
F).
“YES”
“YES”
IAT sensor
Intake air temperature value is fixed to 40
°
C
(104
°
F).
“YES”
“YES”
Diff-lock relay
Differential position signal is fixed to neutral
gear.
“YES”
“YES”
Summary of Contents for 2009 LT-A500XP
