6-14 POWER UNIT
CYLINDER HEAD ASSY
REMOVAL
Before removing the cylinder head assy:
• Remove the power unit. (See page 6-6.)
1. Remove the ten bolts.
2. Remove the cylinder head assy and the gasket.
INSTALLATION
Installation is reverse order of removal with the special attention
to the following steps.
!
Do not re-use the gasket once removed. Always use a
new gasket.
1. Install the gasket and the two dowel pins.
2. Install the cylinder head to the cylinder block.
3. Apply engine oil lightly to the cylinder head bolts.
4. Tighten the bolts to 50 percent (%) of the specified torque
according to the numerical order in the figure.
#
Cylinder head bolt (50% torque):
1st step
37 N·m (3.7 kg-m, 27.0 lb-ft)
5. Loosen all bolt to 0 N·m (0 kg-m, 0 lb-ft) according to the
reverse order. (2nd step)
6. Finally tighten the bolts to the specified torque in two steps
according to the numerical order in the figure.
#
Cylinder head bolt:
3rd step
37 N·m (3.7 kg-m, 27.0 lb-ft)
Final step
73 N·m (7.3 kg-m, 53.0 lb-ft)
7
7
5
5
1
1
3
3
9
9
10
10
10
10
4
4
2
2
6
6
8
8