POWER UNIT 6-27
CAMSHAFT
1. Apply the engine oil to the camshaft and all holder journals.
2. Install the camshaft from the camshaft pulley side.
3. Install the camshaft thrust plate by the two bolts.
4. Apply the engine oil to the lip area of the oil seal
1
.
5. Press fit the oil seal until its top face is lower than the block
face by 0.5 mm.
!
Do not re-use the seal once removed. Always use a new
seal.
6. Make sure the camshaft smoothly rotates by hand.
ROCKER ARM / SHAFT
1. Apply the engine oil to the rocker arms and the rocker arm
shafts.
2. Install the rocker arms, the rocker arm springs, the intake
rocker arm shaft and the exhaust rocker arm shaft.
NOTE:
• Reassemble each rocker arm to its original position.
• The intake rocker arm shaft differs from the exhaust one in
shape as shown. When assembling, make sure of shaft
shape and installing direction.
3. Tighten the ten screws.
#
Rocker arm shaft screw: 11 N.m (1.1 kg-m, 8.0 lb-ft)
Intake
Exhaust
Pulley
side