8-16 POWER TRIM AND TILT
10. Apply the Water Resistant Grease to the PTT rod upper shaft
1
, then insert the shaft through the swivel bracket and the
tilt rod.
(
99000-25160: Suzuki Water Resistant Grease
11. Secure the upper shaft with the snap ring
2
.
8. Apply the Water Resistant Grease to the tilt rod upper bush-
ings
1
, then install the bushings in the tilt rod.
9. Operate the PTT motor to extend the PTT rod upward.
Align the tilt rod with the hole in the swivel bracket as the tilt
rod extends.
(
99000-25160: Suzuki Water Resistant Grease
12. Route the PTT motor cable in through the lower cover and
connect the terminals to the PTT motor relays.
(Cable routing – See the WIRE/HOSE ROUTING section.)