28
2. Auto Trim
Sets the Auto Trim mode.
Set the outboard motor to the full trim down
position. Use the [
] or [
] buttons to select
“Auto Trim”, and press the [SET] button.
Next, press the [SET] button to select either
“ON” or “OFF”.
When the Auto Trim mode is ON, an “
A
” is dis-
played on the multifunction gauge screen.
Diagnosis
Display
Device List
Diagnosis
Display
Device List
Illmination
Ver.
Menu
OFF
Auto Trim
ON
Diagnosis
Display
Device List
Diagnosis
Display
Device List
Illmination
Ver.
Menu
OFF
Auto Trim
ON
NOTE:
• “
A
” is not displayed if the trim position does
not appear on the multifunction gauge
screen.
• The PTT switch operations take priority, even
when the Auto Trim mode is set “ON”.
• If the PTT switch is operated when the Auto
Trim mode is set “ON”, the Auto Trim mode is
interrupted and the “
A
” flashes on the dis-
play. Auto Trim mode engages again when
the engine speed is reduced to 1500 r/min or
below or the outboard motor is set in the full
trim down position.
3. Diagnosis
Press the [
] or [
] button to select “Diagno-
sis” and then press the [SET] button to display
the Diagnosis selection menu.
Current Code
Press the [
] or [
] button to select “Current
Code” and, then press the [SET] button to dis-
play the diagnostic code and/or caution mes-
sage that are currently activated.
(Refer to the CAUTION SYSTEM and DIAG-
NOSTIC SYSTEM section)
Data Output
Current Code
Diagnosis
Current Code
