6A2-12 ENGINE MECHANICAL (K9K ENGINE)
5) Loosen cylinder head cover bolts in such order (“1” to “8”) as
shown in the figure and remove them.
6) Remove cylinder head cover (1).
Installation
1) Remove oil, old sealant and dust from sealing surfaces. After
cleaning, apply sealant “A” to cylinder head sealing surface
area as shown in the figure.
“A”: Loctite 518®
2) Install cylinder head cover to cylinder head as follows.
a) Fit cylinder head cover to cylinder head with new gasket.
b) Tighten cylinder head cover bolts temporarily by hand.
c) Tighten cylinder head cover bolts specified torque by
numerical order as shown in figure.
Tightening torque
Cylinder head cover bolt (a):
Tighten 12 N·m (1.2 kg-m, 9.0 lb-ft) by the specified proce-
dure
3) Connect breather hose to cylinder head cover.
4) Install injector return hose cover, timing belt upper cover (1),
generator upper bracket (2) and injector cover (3).
Tightening torque
Generator upper bracket bolt (a):
40 N·m (4.0 kg-m, 29.0 lb-ft)
5) Install drive belt referring to “Generator Drive Belt Removal
and Installation” in Section 6H2.
6) Connect negative (–) cable at battery.
“1”
“5”
“8”
“4”
“2”
“6”
“7”
“3”
1
“a”: 2 mm (0.08 in.)
“A”
“A”
“A”
“a”
“1”, (a)
“5”, (a)
“8”, (a)
“4”, (a)
“2”, (a)
“6”, (a)
“7”, (a)
“3”, (a)
3
2
1
(a)