ENGINE MECHANICAL (K9K ENGINE) 6A2-37
12) Loosen crankshaft pulley bolt as follows.
a) Lock flywheel using special tool (C).
Special tool
(C): 09916-98110
b) Remove special tools (A) and (B).
c) Loosen crankshaft pulley bolt, and remove crank shaft pul-
ley.
d) Remove special tool (C).
e) Insert special tools (A) and (B) to removed positions at step
b).
13) Loosen timing belt tensioner bolt (2).
14) Remove timing belt (1).
15) Remove timing belt tensioner (5), timing belt pulley and tim-
ing belt inner cover (4), if necessary.
Installation
1) Clean mating surface of oil pump pulley, crankshaft timing
belt pulley and crankshaft accessory belt pulley.
2) Confirm that special tool (A) and (B) is installed to cylinder
block and cylinder head. If special tool(s) is removed, install
special tool(s) referring to “Pistons, Piston Rings, Connecting
Rods and Cylinders Removal and Installation” in this section
or “Camshaft and Tappet Removal and Installation” in this
section.
Special tool
(A): 09919-58110
(B): 09919-58120
