6A2-52 ENGINE MECHANICAL (K9K ENGINE)
8) Install new oil seal (1) together with protector (2) using spe-
cial tool and plastic hammer until special tool comes into
contact with cylinder head.
Special tool
(A): 09911-98120
9) Install cylinder head cover referring to “Cylinder Head Cover
Removal and Installation” in this section.
10) Install camshaft pulley (1) to camshaft (2) as follows.
a) Install camshaft pulley to camshaft with aligning key (3) of
camshaft pulley with key groove (4) of camshaft.
b) Fix camshaft pulley using special tool.
Special tool
(A): 09917-68221
c) Tighten new camshaft pulley nut to 30 N·m (3.0 kg-m, 22.0
lb-ft).
d) Retighten camshaft pulley nut 85°.
Tightening torque
Camshaft pulley nut (a):
Tighten 30 N·m (3.0 kg-m, 22.0 lb-ft) and 85° by the speci-
fied procedure
11) Install special tool into timing belt pulley (1) and cylinder
head hole.
Special tool
(A): 09919-58120
12) Install timing belt referring to “Timing Belt and Tensioner
Removal and Installation” in this section.
13) Check valve lash (clearance) referring to “Valve Lash (Clear-
ance)” in this section.
14) Install engine assembly to vehicle referring to “Engine
Assembly Removal and Installation” in this section.
CAUTION:
Do not touch oil seal (1) so that it is extremely fragile. Be
sure to install new oil seal using special tool (A) and pro-
tector (2) supplied with new oil seal. If it doesn’t follow
the above-mentioned service, it may cause oil leak from
oil seal.
4
3
1
2
(A)
(a)
