ENGINE 3-83
ENGINE REASSEMBLY
Reassemble the engine in the reverse order of disassembly.
Pay special attention to the following points:
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
#
ENGINE BOTTOM SIDE
CRANKSHAFT
• When mounting the crankshaft into the crankcase, it is neces-
sary to pull its left end into the crankcase with the special tool.
NOTE:
Use the front fork oil seal installer and suitable bars
A
as an
attachment.
%
09910-32812: Crankshaft installer
09940-52861: Front fork oil seal installer
#
CRANK BALANCER
• Install the crank balancershafts
1
.
DRIVE BEVEL GEAR
• Install the transtar output driven gear/shaft with a plastic mal-
let.
Always keep the drive belt, drive face and driven face
away from any greasy matter.
Never fit the crankshaft into the crankcase by striking
it with a plastic mallet.
Always use the special tool, otherwise the accuracy of
the crankshaft alignment will be affected.
Summary of Contents for LT-A700X 2004
