ENGINE 3-89
MOVABLE DRIVE/DRIVEN FACE AND DRIVE BELT
• Install the drive belt, as low as possible, between the movable
driven face and fixed driven face by tapping with a plastic mal-
let.
#
• Install the movable driven face assembly
1
.
#
• Tighten the movable driven face bolt to the specified torque
with the special tool.
"
Movable driven face bolt: 110 N·m (11.0 kgf-m, 79.5 lb-ft)
%
09930-40113: Rotor holder
• Install the movable drive face assembly
2
.
NOTE:
Degrease the movable drive face assembly. Use nonflammable
cleaning solvent to wip off oily or greasy matter and make its
surfaces completely dry.
* The drive belt should be installed so that the arrows
on the drive belt periphery point in the normal turn-
ing direction.
* The drive belt contact surface of the driven face
should be thoroughly cleaned.
Pull the center are a
A
of upper and lower belt lines to
be close to each other to prevent the belt from
expanding.
Summary of Contents for LT-A700X 2004
