ENGINE 3-93
• Hold the crank balancer drive gear nut with the special tool
and tighten the crank balancer shaft driven gear bolts to the
specified torque.
%
09924-52460: Socket wrench 52 mm
"
Crank balancer driven gear bolt:
50 N·m (5.0 kgf-m, 36.0 lb-ft)
OIL PUMP
• Apply THREAD LOCK to the oil pump mounting bolts.
/
99000-32050: THREAD LOCK “1342”
• Install the washer
1
and pin
2
.
NOTE:
Be careful not to drop the washer
1
and pin
2
into the crank-
case.
• Install the oil pump drive gear
3
with chain
4
.
• Install the snap ring
5
.
NOTE:
Be careful not to drop the snap ring into the crankcase.
CAM CHAIN TENSIONER
• Install the cam chain tensioner
1
along with the washer
2
.
• Tighten the cam chain tensioner bolt
3
to the specified
torque.
"
Cam chain tensioner bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
GENERETOR
• Install the starter driven gear
1
.
• Install the key
2
.
NOTE:
Degrease the tapered portion of the generator rotor assembly
and also the crankshaft. Use nonflammable cleaning solvent to
wipe off the oily or greasy matter to make these surfaces com-
pletely dry.
Summary of Contents for LT-A700X 2004
