8-18 CHASSIS
INSPECTION AND REASSEMBLY
Inspect the boots for wear or damage. If any damages are
found, replace them with new ones.
Inspect the axle play by using a push-and-pull motion given to
the axle shaft and wheel spindle, as shown.
NOTE:
* Wash the disassembled parts (except for the boots). After
washing, completely dry the parts using compressed air.
* Clean the boots with a cloth.
$
• Fit a boot on the drive shaft end, fitting the small diameter side
of the boot to the shaft groove, fix its end with a new band.
• Install the cage
1
on the shaft.
$
A
Large diameter
B
Small diameter
* Wash all parts before installation, clean the inside
and outside of the boots with a cloth.
* Do not wash the boots in any commercially available
degreaser, such as gasoline or kerosene. Washing in
a degreaser causes deterioration of the boots.
Install the cage with the large diameter side facing the
shaft end.
Summary of Contents for LT-A700X 2004
