CHASSIS 8-23
BRAKE PAD REPLACEMENT
• Remove the front wheel. (
!
8-13)
• Remove the brake caliper mounting bolts
1
and brake pad
mounting pins
2
.
• Remove the brake pads.
$
• Install the new brake pads.
• Apply thread lock to the brake pad mounting pins and brake
caliper mounting bolts.
• Tighten the brake pad mounting pins and brake caliper
mounting bolts to the specified torque.
#
Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
"
99000-32050: THREAD LOCK “1342”
#
Brake caliper mounting bolt:
26 N·m (2.6 kgf-m, 19.0 lb-ft)
(
99000-32030: THREAD LOCK SUPER “1303”
NOTE:
After replacing the brake pads, pump the brake lever a few times
to check for proper brake operation and then check the brake
fluid level.
* Do not operate the brake lever during or after brake
pads removal.
* Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
Summary of Contents for LT-A700X 2004
