CHASSIS 8-31
• Install the wheel hub.
• Install the front caliper. (
!
8-27)
• Tighten the front wheel set nuts
2
, and hub nut
3
to the
specified torque.
#
Front wheel set nut: 60 N·m (6.0 kgf-m, 43.5 lb-ft)
Front hub nut: 110 N·m (11.0 kgf-m, 79.5 lb-ft)
NOTE:
* First, remount the front wheels, and then tighten the front hub
nut to specified torque.
* After tightening the front hub nut, insert a new cotter pin into
the driver shaft.
MASTER CYLINDER REMOVAL AND
DISASSEMBLY
• Place a rag underneath the brake hose union bolt on the mas-
ter cylinder to catch any spilt brake fluid. Remove the brake
hose union bolt and disconnect the brake hose.
$
• Remove the master cylinder assembly.
• Disconnect the front brake switch coupler
1
.
Immediately wipe off any brake fluid contacting any
part of the vehicle. The brake fluid reacts chemically
with paint, plastics, rubber materials, etc., and will
damage them severely.
Summary of Contents for LT-A700X 2004
