2-20 PERIODIC MAINTENANCE
REMOUNTING
Remount the drive belt in reverse older of removal. Pay attention
to the following points:
• Insert the drive belt, as low as possible, between the movable
driven face to provide the maximum drive belt clearance
before installing.
• Install the movable driven face with drive belt to the drive
shaft and temporally tighten the nut.
#
• Install the movable drive face assembly.
NOTE:
Degrease the movable drive face assembly. Use nonflammable
cleaning solvent to wip off oily or greasy matter and make its
surfaces completely dry.
• Install the callar and movable drive face bolt.
NOTE:
Be careful direction of the collar.
* Fit the drive belt to the movable driven face so that
the arrows on the drive belt outer surface aim toward
normal turning direction.
* The drive belt contact surface of the driven face
shoud be thoroughly cleaned.
Summary of Contents for LT-A700X 2004
