5-24 FI SYSTEM DIAGNOSIS
SHOW DATA WHEN TROUBLE
(DISPLAYING DATA AT THE TIME OF DTC)
ECM stores the engine and driving conditions (in the form of data as shown in the figure) at the moment of
the detection of a malfunction in its memory. This data is called “Show data when trouble”.
Therefore, it is possible to know engine and driving conditions (e.g., whether the engine was warm or not,
where the vehicle was running or stopped) when a malfunction was detected by checking the “Show data
when trouble”. This “Show data when trouble” function can record the maximum of two Diagnostic Trouble
Codes in the ECM.
Also, ECM has a function to store each “Show data when trouble” for two different malfunctions in the order
as the malfunction is detected. Utilizing this function, it is possible to know the order of malfunctions that
have been detected. lts use is helpful when rechecking or diagnosing a trouble.
Summary of Contents for LT-A700X 2004
