11
5mm
5. TYPE OF CLOTH CLAMP
Four types of cloth clamp are prepared for the machine. Details as follows:
1) Flat type of cloth clamp
a) Part No. S1-2791A(right) and S1-2792A(left) for buttonhole size 14mm ~ 27mm
b) Part No. S1-2791(right) and S1-2792(left) for buttonhole size 27mm ~ 40mm
NOTE: Machine model SE200-MS is equipped with above b) as standard clamp.
2) Wedge type of cloth clamp
Part No. SZ-2791(right) and SZ-2792(left) for buttonhole size 14mm ~ 35mm
NOTE: Machine model SE200-MJ is equipped with above parts as standard clamp.
ADVISE: When making buttonhole to the position of waistband, we recommend you to use wedge type of
cloth clamp. When changing from flat type to wedge type or reverse of it, adjust the cloth clamp height.
6. OILING
CAUTION : Switch off the main switch before oiling.
When lubricating the machine, use high quality sewing machine oil.
Please check the oil tank whether oil comes to the red line (max.) before operating the machine. If oil is
not enough, add it until it comes to the red line (max.). The oil tank must be checked once a week at
least before operating and also put some oil into other all holes marked oil OIL once a week.
Oil tank located machine arm Oil tank located bed base(under feed table)
Lubrication hole
for oil tank
Oil line should be
lower about 5mm
from lubrication hole.
Lubrication hole
