2
-
Leaving the work place unattended.
-
Maintenance work.
-
When using clutch motor without actuation lock, wait until the motor has completely stopped.
・
Always be aware of moving parts such as needle(s), knife/blade and cloth feed table etc., do not turn
your attention from the machine while running.
・
Never operate the machine if it has damaged cord or plug, if it is not working properly, if it is dropped
into water etc. and if a fabrics or yarns for sewing are damp or wet.
・
Never drop or insert any object into any opening places/points of the machine.
・
Pay attention to your hand etc. carefully when the cloth feed table is working.
・
Never touch or be close your hand or other to the knife when in working.
・
Never touch or be close your hand or other to the needle bar or needle when in working.
E) NOTICE
Be sure to read the operation manual thoroughly before attempting to operate the machine. After
reading, be sure to keep this manual near the machine any time to read again.
1) Conditions of operating the machine
・
A place of operating the machine should be dry and should not be under the influence of the source
of high electromagnetic waves or noise.
・
Rated voltage which is name plate on the machine should not exceed
±
10%.
・
A limit of operating environment is ; Temperature 5
℃
~ 35
℃
, Humidity 35% ~ 85%
・
Switch off the main switch and pull out the main plug, when in danger of thunderbolt.
・
Check the electrical devices to prevent the electrical shook etc. before switching on the main switch
when changing the environment from cold place to warm one
・
Check the main voltage before the cord plug plugs in. Main voltage is indicated on cord plug and
machine number serial plate.
2) Conditions for delivery, stock, opening, setting and handling
・
In case of delivery the machine, never drop, overthrow and damage to the carton box.
・
When re-packing and delivering the machine, fix the machine table and bed with band and use the
original carton box. In case of stock of the machine in the warehouse, never pile the carton box,
over two (2) cartons and lain piled is prohibited. Place for stock of the machine should be dry.
・
To prevent unexpected accidents when opening the carton box and setting the machine on the table,
pay attention sufficiently and work with over two (2) persons.
・
When setting the machine on the table, pay attention carefully and order the setting in accordance
with page 7 ~ 8.
3) Emergency button
When in emergency such as thread breakage, needle broken or other problem while the machine is
working, push the emergency button immediately.
How to recover the machine from emergency stop;
・
Switch off the main switch, wait for 2 ~ 3 sec. and switch on the main switch again.
・
Press the start and left foot switch at the same time.
The needle bar comes to the highest position and the feed table returns to the original/start position
without sewing, and the cloth clamp opens/unlocks automatically.
Never touch electronic devises or open the motor cover/control box cover because electricity is still
supplying even if the emergency button is on.
4) Repair, maintenance or adjustment
・
If alterations are made to the machine, all of the machine safety rules must be considered.
