CV0204DVR
38
SVAT ELECTRONICS
Now You Can See
6.4.3.2 DHCP
The “DHCP” is automatically set as the default network setting of the Network DVR.
When a Network DVR is connected into the LAN, it will issue DHCP packets to request
an IP address that is dynamically assigned by the DHCP server. If it is unable to get a
DHCP address, the Network DVR will assign a default IP address such as
“169.254.1.13”.
6.4.3.3 CONNECT TO ADSL BY PPPoE MODE
To setup follow the steps below:
1.
After setup, rebooting enables automatic connection to ADSL.
2.
Enter the “Username” and “Password” fields with the account and password
provided by the ISP.
3.
If item “Send mail after connected” is selected, the mail will be automatically sent
when connected to the ISP.
4.
Click “OK” button to save the settings.
Note:
In order to activate the function, it is necessary to reboot the device after the setup.
ADSL Setting Display
If the Network DVR and ADSL modem are connected by a hub, the user can select “Dial
On Power Up” to perform the connect operation. However, if the Network DVR and ADSL
modem are connected directly, then please note the following steps below.
1.
Power off Network DVR.
2.
Connect Network DVR directly to the ADSL modem (using RJ-45 Ethernet port).
3.
Power-up Network DVR.
4.
Network DVR will start dialing.
5.
Once connected, mail the IP address information to the preset e-mail address.
6.
After 10 times of connection failure, it aborts the operation and the user can
reconnect it by LAN to find the cause.
