15
Operating Maintenance Installation CLASSIC PIZZA 860005-02
Heat controls
The Classic Pizza oven is fitted with three groups of ele
-
ments which can be regulated separately. These groups are
called TOP HEATING, BOTTOM
HEATING, and FRONT HEATING.
Top and bottom heating are used to influence the properties
of the baked product. The main purpose of the front heating
is to compensate for the heat losses at the oven door.
Certain commissioning time can be expected before you
find your own setting.
To start with you can use the values below (fig 9), and then
adjust to your own settings.
BAKING
Description of AC guard (current delimiter)
The oven calculates the present power consumption.
”The maximum allowed current” is set in the service menu
(see under Setting of service parameters). The power
consumption is not allowed to exceed this value. If one
deck is disconnected because of a too high power con-
sumption, the temperature symbol on the display flashes.
In the service menu you select which of the oven chambers
is to be given priority, when the power consumption is too
high. From factory the lower oven chamber has been given
priority. When the power consumption no longer is needed,
the panel will automatically disconnect this function and the
temperature symbol will stop flashing.
Built-in current delimiter
Description of turbo function
The oven is fitted with an automatic turbo function. If the
difference between and pre-set and real temperature is
larger than a value set in the service menu, all heating ele-
ments will be given full power to quickly regain the correct
working temperature.
Built-in turbo function
