19
Operating Maintenance Installation CLASSIC PIZZA 860005-02
TROUBLE SHOOTING
Trouble shooting
In the event of a problem you should first look through the trouble shooting list below to see if you can correct the
fault yourself. If this does not help contact Sveba-Dahlen’s service department.
NOTE! Work on electrical components must be carried out by an authorized electrician.
Table 2 Trouble shooting.
The oven does not start.
• Oven fuse blown.
• Main fuse blown.
• Reset fuse in the oven distribution box.
• Replace fuse in the main distribution box.
Fault
Reason
Procedure
The oven drops in
temperature or has long
recovery time.
• Damper open.
•
A fuse/overheating protection has blown.
• Defective element.
• Close damper fully or partially.
• Reset fuse/overheating protection in the oven
distribution box.
• Replace defective element.
The top of the product is
too dark.
• Too much top heat
• Reduce top heat.
The bottom of the
product is too dark.
• Too much top heat.
• Reduce top heat.
Both the top and bottom
of the product are too
dark.
• Too high baking temperature.
• Too long baking time.
• Too much top heat
• Reduce baking temperature slightly.
• Reduce baking time slightly.
• Reduce top heat
The product is lighter at
the front of the oven.
• Too little front heat.
• Too much top heat.
• Increase front heat 1 step.
• Reduce top heat 1 step.
The product is darker at
the front of the oven.
• Too much front heat.
• Too little top heat.
• Reduce front heat 1 step.
• Increase front heat 1 step.
The oven bakes unevenly
on certain surfaces.
•
Static relay broken
•
Change the static relay
Note: only by authorized electrician.
