8
ENG
Home Theatre Speaker
System 5.1
9. OPERATION GUIDE
Switching On
•
To switch on subwoofer, plug power cable (
i
,
fi
g. 1) of subwoofer into the mains outlet. Adjust
volume level to its minimum by turning VOLUME control knob (
b
,
fi
g. 1) on the front panel of
subwoofer counterclockwise as far as it would go. Shift POWER
On/O
ff
switch into ON position
g
the rear panel of subwoofer. Adjust volume level by turning VOLUME control knob
b
on the front
panel of subwoofer or by pressing buttons or MASTER– (
g
,
fi
g. 3) on remote control
(see
fi
g. 3). If HTSS is in the MUTE mode of temporal shutdown of sound, press MUTE button (
a
,
fi
g. 3) on remote control to turn on sound.
•
To select between stereo and 5.1-channel sound source, it is necessary to press button 5.1/2.1
(
c
,
fi
g. 3) on the remote control alternately.
General volume control
•
By pressing MASTER (
g
,
fi
g. 3) buttons («+» or «– ») on the remote control, it is possible to
adjust (to increase / to decrease) the level of general volume of the system. General volume control
possible also can be adjusted by the knob
b
on the front panel of subwoofer
.
Volume control of center and rear satellites and subwoofer
•
For properly adjusting volume level of center (CENTER) and rear (REAR) satellites and
subwoofer, use buttons
d
,
e
and
f
(«+» or «– ») on the remote control to adjust volume level of
corresponding channels. Volume level of channels and HF level can be also adjusted by knobs
a
and
c
(
fi
g. 5) on the control panel of subwoofer.
•
By pressing button SR (
b
,
fi
g. 3) on the remote control while listening to stereo signal, center
and rear channels (Surround mode) start working, which produces an impression of dimensional
sound.
Mute feature
Press MUTE button (
a
,
fi
g. 3) on the remote control or the same button on control panel of
subwoofer to temporarily turn o
ff
the sound. Press this button again to turn on the sound.
Notes:
• If HTSS has not been used for a long time, please mind to switch off
g
(position OFF) on
the subwoofer rear panel and unplug it.
• To enhance sound quality, use Line-Out output of sound card.
