Switching on
•
Adjust the volume level to the minimum and connect the power cord
m
to the mains outlet.
•
Switch on the HTSS power supply with the POWER ON/OFF switch (
l
, ON position) on the
subwoofer rear panel. The power LED
c
on the front panel will illuminate. Press the STANDBY
a
button on the RC or STANDBY
g
button on the subwoofer control panel, and the LED display (
a
,
Fig. 1) will illuminate. The STANDBY function is designed for switching the system on/o
Ԛ
quickly
and saving electricity.
Selecting audio source
•
The HTSS has two stereo audio inputs (AUX and DVD(5.1CH)) on the subwoofer rear panel and an
SD slot and USB port on its top panel. The system will automatically enter the Player mode when a
USB device is connected to the USB port
l
or an SD card is inserted into the corresponding slot
k
. According to the necessary connection, select the audio source with the INPUT
j
button on
the control panel or button
b
on the RC. The subwoofer LED display
a
will show the input
selected.
Notes:
•
If the USB port and SD card slot are used at once, you can select the necessary source
by successively pressing the INPUT
j
button on the subwoofer front panel or button
b
on
the RC.
•
SD/USB
О
ash storage devices with capacity higher than 8Gb may work incorrectly – data
processing may be delayed.
Master volume control
•
Adjust (increase/reduce) the master volume with buttons VOL+/–
f
on the RC.
Subwoofer and satellite speaker volume control
•
The bass and treble level can be adjusted with BASS +/–
g
and /–
p
buttons
respectively on the RC.
•
The rear and center speaker volume can be adjusted with REAR +/–
j
and CEN+/–
d
buttons
on the RC. The SW +/–
k
RC buttons are used for adjusting the subwoofer volume control.
Pro.logic 3D sound effect
•
This feature can be activated if the sound is played via the stereo input. To use this feature, press
the SOUND
c
button on the remote control or SOUND
i
button on the subwoofer control panel.
The LED dieplay
a
will show Pro.Logic. The processed stereo signal will play from 5 satellite
speakers and the subwoofer. Press these buttons again to deactictivate this feature.
Switching off the sound
•
Press the MUTE
h
button on the RC to switch o
Ԛ
the sound. Press this button again to switch the
sound on.
FM tuner mode
•
The FM mode is selected with the INPUT
j
button on the subwoofer control panel or INPUT
b
button on the RC.
Auto radio station search
•
Press and hold down the TUN+
o
button on the RC for more than 1.5 seconds to activate the auto
radio station search and memorizing (no more than 30 stations).
•
To tune to the memorized radio stations, press the CH
q
button on the RC, and then select the
necessary channel with the TUN+/–
o
buttons.
ENG
9
IHOO T100U
Operation Manual
