•
Insert the power cord plug
m
into the mains outlet.
•
Switch on the device using the POWER switch (
l
, ON position) on the rear panel of the active
speaker. The power LED
b
will light up. Switch on your audio source, press the ST-BY
a
button or
turn the VOLUME knob
e
on the speaker and then select the connected audio source with buttons
AUX
c
, LINE IN
b
or PC
i
on the remote control.
•
Adjust the master volume by turning the VOLUME
e
knob or pressing the VOL+
d
and VOL-
f
buttons on the remote control. To increase the volume, turn the VOLUME
e
knob clockwise, to
reduce the volume, turn the knob counterclockwise.
•
Adjust the treble and bass level by turning the TREBLE
c
and BASS
d
knobs respectively or
pressing the /-
g
and BASS+/-
k
buttons on the remote control. To increase the treble
and bass level, turn the knobs clockwise; to reduce it, turn the knobs counterclockwise.
•
Using buttons L/R
e
, adjust the balance between left and right channels.
•
To enter the MUTE mode, press the MUTE
j
button on the RC. To exit the MUTE mode, press
this button again.
•
Connect your headphones to the headphone jack
g
.
Notes:
• If the MSS is left unused for a long period of time, please mind to switch it off with the
POWER
l
switch on the rear panel of the active speaker (OFF position) and unplug the
power cord
m
.
•
Though the MSS has three switchable inputs, you can turn on only one audio source at
a time.
• To improve the sound quality, use the Line Out port of your sound card.
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product yourself.
Problem
The MSS does not
turn on.
No sound or the
sound is too quiet.
Distortion of sound.
The remote control
is not working.
Cause
The MSS isn’t connected to a mains
outlet.
The power switch is o
ff
.
Volume level is set at minimum value.
Improperly connected audio source.
Large amplitude of the input signal.
The battery is discharged.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect the audio sources correctly.
Turn down the source volume and
the MSS volume.
Replace the battery with a new one.
6. TROUBLESHOOTING
ENG
6
2.0 Multimedia Speaker System
