HDR-106
MPEG2/H264 – 4:2:2 – 10 bits – DVB-T2/T Diversity 6 – DVB-S2/S Receiver
MANUAL 7.0
Chapter 3: Receiver Operation and Menus
This section contains all the necessary information to operate, control and
configure the HDR-106 receiver.
3.1
Display
To switch the equipment on and off, press On/Off button. When the
equipment is turned on, the display will show the start-up message (model
of the equipment), and then it will display the first main screen. So as to
change from one main screen to another, the OK button must be pressed.
1
st
main screen:
displays the most important parameters of the
received signal.
2
nd
main screen:
shows signal reception conditions, level and quality
(for DVB-T2 and DVB-T).
3
rd
main screen:
displays the level of the six received signals in the
whole screen (for DVB-T2 and DVB-T).
4
th
main screen:
displays the level and the C/N value of the received
signal with the better values of these parameters when it is working in
diversity mode (for DVB-T2).
It is important to consider that the 1
st
main screen is different depending on
the standard of the received signal and the selected input.
Next, there are shown the linkages between the input and the character
displayed in the principal screen:
Audio
A
Data
DATA
D
GPS
G
Table 3.1 Linkages between the input and the character displayed
Next, the main screen for each input type (DVB-T2, DVB-T, ASI and IP) is
shown:
Summary of Contents for HDR-106
Page 208: ...207 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0...
Page 209: ...208 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0...
Page 210: ...209 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0...
Page 211: ...210 HDR 106 MPEG2 H264 4 2 2 10 bits DVB T2 T Diversity 6 Receiver MANUAL V7 0 Notes...
