Username and password for logging into any device is “admin” and “password”.
Entering this information into browser brings up the unit control page.
N3121 Encoder Rear*
N3221 Decoder Rear*
*Note: models may not have all
connectors and options
Congratulations on the purchase of your N3000 series products. An SVSi
Networked AV system comprises video and/or audio encoders, decoders, and
other network accessories including recording solutions, multi-window processing,
audio only end points, and system controllers. The system allows you to distribute
HD Video, Audio and Control across a gigabit Ethernet network. Options are
available for recording, playback, windowing, and wall processing.
The N3000 video-over-IP stream is a multicast transport stream that is not
compatible with WAN (internet) transmission. For WAN streams, select [Unicast]
and enter the destination IP address. If outside the current network of the N3000
encoder, a router, port-forwarding, or VPN must be used. Please see your IT
administrator for these options. RTP encapsulation is an option required by certain
third-party h.264 decoders – SVSi's N3000 decoder does not require this option.
If multiple units need to be configured during initial set-up, NetLite allows exporting
of a comma-separated (csv) file of all discovered units that can be edited and then
reimported. Once imported, all device parameters will be configured as entered in
the csv file.
Common trouble-shooting items are improper network address, subnet mask, or
gateway; improperly configured network switch, decoder assigned to non-existent
stream number, If devices will not display anticipated video, disconnect from AV
network and connect encoder directly to decoder for testing. Units must be
pre-configured first before direct connection. Transmission of an N3000 stream
over the internet will require additional steps involving your IT infrastructure and
appliances. Please see your IT administrator or call SVSi tech support if unsure of
steps involved.
Please contact SVSi technical support at support@svsiav.zendesk.com or (256)
461-7143 x9900 for any installation issues.
Network Bandwidth per video stream = 0.032-10Mbs (user-selectable)
Analog or digital video is input through the DVI-I connector on the N3000 encoder
and converted to network packets for output through the RJ-45 connector. Audio
can be input as embedded digital audio through the DVI-I connector or as
balanced analog audio through the 5-pin phoenix connectors. Both encoder and
decoder can be powered 12V externally with optional wall-wart or by
power-over-Ethernet (PoE).
The N3000 series decoder accepts the network packets and reconstitutes
synchronized video and audio for display through its DVI-D port. Digital only video
is output by the decoder. The streaming h.264 output of the N3000 can also be
decoded in software with the free VLC Player application available from
http://www.videolan.org/vlc/index.html.
IR and Serial commands can be transmitted by either encoder or decoder using
SVSi's free NetLite configuration software, SVSi's N8000-series controller, or
using third-party controllers. IR and serial ports are not pass-through and must use
a central controller to direct commands to each device.
Optional accessories:
N9312 12V wall-wart
N6123 dual-channel networked video recorder
N3510 4x1 windowing processor (available Q4-2013)
N3000 SERIES
QUICK START
© Southern Vision Systems, Inc. • 256.461.7143 • www.svsiav.com
SVSi and voLANte are trademarks of Southern Vision Systems, Inc. in the United States and other countries.
800DOCN3000QSREV1.0
Distribution | Switching | Recording | Windowing | Wall Processing | Control
Made in the U.S.A
