10207L
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
www.swstahl.de
SW-Stahl GmbH
Tel. +49 (0) 2191 / 46438-0
An der Hasenjagd 3
Fax +49 (0) 2191 / 46438-40
D-42897
Remscheid
E-Mail:
info@swstahl.de
OPERATION ADVICE
•
Rotate the drive nut to drive the jaws apart to match the length of the spring and
to compress as many windings as possible. See below.
•
Make sure the spring is clean where the jaws are mounted on the windings.
•
Preload compressor by turning the hand wheel until the jaws has a firm
grip on the spring. See figure J.
•
Compress the spring by rotating the drive nut using a socket wrench.
•
Do not continue to drive when the upper or lower travel ends of spring
compressor are reached.
•
When the spring has been safely compressed, remove the top bearing of the strut.
•
Before removing the bearing recheck that the spring is still firmly seated in the
jaws. See figure K.
Figure I
Figure J
