SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: info@swstahl.de
21055L
B
E
D
IE
N
U
N
G
S
A
N
L
E
IT
U
N
G
/
I
N
S
T
R
U
C
T
IO
N
M
A
N
U
A
L
Important notes
1. If the device gets contact with silicone vapors, the sensor will be dirty. Avoid the use
of the device where silicone vapors are present, where cleanser are used and where
rubber is processed.
2. Avoid environments with a high concentration of corrosive gases such as H2S, SOx,
CI2, HCI,
etc. The device could otherwise corrode and the main line and the heating unit of the
device could be damaged.
3. Measurement errors can occur when the probe is contaminated with alkaline metals
or salt water vapor comes into contact.
4. Measurement errors can be caused by contact with water (spray).
5. If probe comes in contact with water, the measurement results be distorted.
6. The device works best at an ambient air with an oxygen content of 21%. The device
does not work in an environment without oxygen or air with less than a 21%.
7. Slight condensation of the device if used in enclosed spaces should not be a
problem. However, If condensation liquid collecting on the probe, the measurement
results would be distorted.
8. With a longer exposure of the device with high-concentration gases - even if the
device is switched off - in future the measurement can be distorted.
9. If the device is switched off for a long time, the probe could produce slight
Measurement inaccuracies (whichever is how the device has been stored). So the
device should be stored in a sealed bag / bag of clean air.
10. Regardless of the power supply, the device will severely suffer if the probe extreme
Conditions such as humidity, high temperature, or prolonged contamination with
gases for a long period will be suspended.
NOTE: If not using the meter for long time, the device needs a longer warm-up phase.
You can switch it on from time to time, to avoid a long warm-up phase.
