SWAGTRON
TM
SWAGdRONe
TM
4-UP Racing Quadcopter Goggle Quick Start Guide
11
AV Output:
Sending the 4-UP’s signal to external devices will require AV output. Use an AV
cable to connect the 4-UP and an external device via the AV Output Port.
* AV cables not included.
12.0 Troubleshooting
No image on the display
1. Check to ensure the 4-UP is receiving power and the receiving module has been
turned on.
2. Ensure that the 4-UP’s receiving channel is consistent with the transmitter’s channel.
3. Ensure the transmitter (if using one) has adequate power.
4. Ensure all cables are properly connected and all plugs are fully inserted.
5. Ensure all antennas from the 4-UP and the transmitter (if using one) are properly
installed and extended.
Image quality is poor and/or wireless transmitting range is short
1. Check surroundings for other transmitting devices that may be working on the same
frequency. Select another frequency to prevent interference or use your 4-UP in
another location.
2. Ensure all antennas from the 4-UP and the transmitter (if using one) are properly
installed and extended.
3. Ensure there are no large obstacles between the 4-UP and any transmitter (if using
one) including buildings, trees, hills etc. For optimal performance, only use the 4-UP in
wide, open spaces.
AV Input Port
AV Cable
AV Cable
AV Output Port
