12
3.3 Tire Inflation
You will need a pressure gauge, a standard bicycle pump, and the included valve extender to inflate the
Swagger 7’s tires.
Step 1.
Make sure the scooter is powered off and stable, so it doesn’t move during inflation.
Step 2.
Visually inspect the front tire for damage, scuff, or puncture marks. If the front tire is damaged, DO NOT
INFLATE IT. Contact customer service immediately.
Step 3.
Find the valve located on the inside of the wheel and remove the cap.
Step 4.
Use a standard bicycle pump to pump air to the front tire slowly. If needed, use a valve extender.
Step 5.
Use the pressure gauge periodically to check PSI.
Step 6.
When the tire reaches 50 PSI / 3.4 Bar stop inflating and replace the valve cap.
Step 7.
Repeat operations on the rear tire.
•
Any PSI marking on the tires indicate a maximum. DO NOT inflate the both tires to this value. Only inflate
it to 50 PSI as directed above.
•
Under inflation is strongly recommended if you intend to ride outdoors in temperatures above 90°F
degrees. Bring the Swagger 7 indoors and deflate the tires to 45 PSI. If the PSI is too high and the tire
are exposed to excessively high temperatures, riding outdoors may cause serious damage to the tires
including but not limited to stretching and/or rupturing.
Summary of Contents for SWAGGER 7
Page 2: ......
