SWAGTRON SWAGGER 7 USER MANUAL 13
Section 4
CHARGING
Charge the Swagger 7 before using it.
4.1 Charging the Battery
The charge cycle is complete when the battery indicator on display is full. Each
charge cycle from zero to full charge will take 3~4 hours. When the backlit
display on the handlebars indicates that battery power is low, recharge the
Swagger 7. Only use the included charger to recharge the Swagger 7.
You can charge the Swagger 7 battery when it’s installed in or detached
from the scooter.
Step 1.
Make sure the scooter is powered off. Then locate the charging
port at the bottom of stem or the bottom of the battery, if
detached (see. 4.2 Removing the Battery).
Step 2.
Plug the charger into a wall outlet (100V-240V) then plug the
other end into the charging port. Remove the cap as needed.
Step 3.
While the scooter is charging, the charger light will turn red.
Step 4.
When the scooter is fully recharged, the charger light will turn green. You
may then disconnect the scooter from the charger.
DO NOT, under any circumstances, use the scooter while it is charging or
connected to the charger.
The charging time is 3~4 hours. Charging longer than that may affect battery life and/or performance. If the
charger’s light doesn’t turn on, it may not be fully connected. Check that it is securely connected to the wall
and to the scooter.
Charging Port
Charging Port
Battery
Summary of Contents for SWAGGER 7
Page 2: ......
