•
Avoid sudden turns while riding fast, as this may result in an accident.
•
Do not step on the center pivot point of the zipboard.
3.3. CALIBRATION
If your Shuttle Zipboard Swagboard seems to pull to the left or right during your ride, you may need to recalibrate its sensors.
The calibration process requires a flat stable surface and a level. Levels may be purchased separately at most hardware stores or
level apps may be downloaded with most smartphones.
STEP 1.
Turn off the zipboard.
STEP 2.
Adjust the zipboard so both pedals are level. Using a level tool is recommended for accuracy.
STEP 3.
With the zipboard level, press and hold the power button for about six seconds, until you hear a single beep.
The lights will begin flashing and the zipboard will calibrate itself. Remove your finger from the power button
after you hear the beep and the zipboard will power off. The zipboard is now calibrated.
STEP 4.
Make sure the pedals are level, then press the power button again to turn the zipboard off.
STEP 5.
Turn the zipboard on and try riding to check calibration.
If the Shuttle Zipboard Swagboard is still not calibrated correctly, repeat steps 1-5 at least two more times before calling
customer support for additional assistance.
