(6)
Your system is equipped with high-quality Neutrik Speakoncompatible loudspeaker connec-
tors, which ensure safe and trouble-free operation. The Speakon connector was especially
developed for high-power loudspeaker. Once it is plugged in, it safely locks into position a-
nd cannot be accidentally disengaged. It prevents the occurrence of electrical shock and
ensures the correct polarity. Each of the connectors carries only the assigned single signal
(see tab.4.1/fig.4.5 and the information on the rear panel of the power mixer).
5.3 Loudspeaker connection
(23)
(22)
(20)
(19)
(21)
(1)
(8)
(3)
(7)
(13)
(16)
(14)
(18)
(17)
(12)
(4)
(10)
(9)
(11)
(15)
(6)
(2)
(5)
(1) The HIGH control in the EQ section governs the high-frequency range of the respective
channel.
(2) The LOW control allows you too boost/cut the low-frequency range.
(3) The FX control determines the signal level sent from each channel to the built-in effects
processor.
(4) The LEVEL control adjusts the channel signal level in the main mix.
(5) The CLIP LED is very useful to control the input gain, It should never be constantly illu-
minated (only with signal peaks).
(6) The PAD switch reduces the input sensitivity of the channel by appros. 20 dB, to conn-
ect for example line-level signals.
(7) The balanced LINE IN input (1/4
TRS) can be used for line-level signal sources, e.g.
Keyboards.
(8) Each channel has a balanced MIC microphone input with XLR connectors. Please rem-
ember to use either the microphone of the line input of a channel at a time, but never
both at the same time!
★
″
Please note that the effects processor signal will be inaudible when the FX LEVEL
control((16)) is set fully counter-clockwise.
(3)
3. CONTROL ELEMENTS
3.2 Effects section
3.1 Input channels
(9)Turn the PROGRAM control to select an effects preset (preset number starts flashing). P-
ush the control briefly to confirm your selection.
