Swann Ceramic Series, Manual

1.  Connect the appliance to a suitable socket outlet. Press power switch on control 

panel, a Beep sound will be heard and the power indicator light lights up. It 

shows that the unit has been connected to the power supply.Press steam selection 

switch to turn off all 3 steam indicator lights ,it is ready for dry ironing.

2.  Set temperature control dial to desired position according to above fabric setting 

chart. Temperature indicator light  in iron unit will light up to indicate that the steam 

chamber being heated up. When temperature indicator light turn off, it indicates 

that desired temperature has been reached ,it is ready for dry ironing. During use, 

it is normal that heating indicator light will cycle from on to off, and then off to on. 

This shows that steam chamber automatically keeps temperature constant.

3.  During use,please press steam lock every 15 minutes. Otherwise, iron will 

automatically shut off.(Refer to auto-shut off function).

4.  After use, Set the temperature control dial to “MIN” position, and place the iron 

back on the iron rest plate. Switch off the unit by pressing the power switch and 

then unplug the appliance from the outlet.

Note:  

When changing your Temp setting from higher setting to lower, it is advised 

not to start ironing immediately since it may cause burns to your fabrics. 

Please wait until temperature indicator light lights up steadily, 

and then start ironing.

8

Dry ironing

How to use your steam generator

5.  During steam ironing, please adjust steam rate according to your requirement as 

indicated in the steam function setting.

6.  After use, Set the temperature control dial to “MIN” position, and place the iron 

back on the iron rest plate. Switch off the unit by pressing the power switch and 

then unplug the appliance from the outlet.

7.  Slide out the water tank and pour out the remaining water.

Note:

a.  For every first time use, it is normal that a slight vibration sound may be 

heard from electrical pump inside the base unit for about 10 seconds when 

steam ironing started. It is because there is air inside the filter, it will stop when the air 

inside the filter has been pumped out. If this sound continues 

for more than 30 seconds, please check whether water tank and filter are 

assembled correctly or not.

b.   During use, if steam stops along with 5 BEEP sound alarm, or 

water tank indicator light and water filling indicator light on control 

panel blink. This indicates that it is time to fill water tank.

c.  For continous use of steam ironing, sometimes pump working indicator light will 

turn off for several seconds,steam also will stop for several seconds. This is 

normal. It is because anti-drip function has been activated to protect leakage from 

soleplate.