Swann Chesapeake CH1B-2225, Manual

Accessibility Requirements

Note: 

  Only lavatory installations in a public space must  

comply with the knee and toe clearance 

dimensions,however we recommend these standards 

be used for both private and commercial installations. 

Also makesure that all state and local building codes  

are followed when installing this unit.



m

The top of the vanity should not exceed 34” (86.4 cm) from 

the floor. 



m

The “knee space” below the apron of the vanity top should 

be a minimum of 27” (68.6 cm) from the floor. 



m

The front edge of the sink should be between 17” (43.2 cm) 

and 25” (63.5 cm) from the wall. 



m

The faucet should be a maximum of 19” (48.5 cm) from the 

front of the sink. 



m

No part of the sink or the plumbing should be within the gray 

area shown in the drawing.

Care and Cleaning

The Swanstone products are stain and abrasion resistant; 

however, the finish requires reasonable care.
Because cleaning products change over time, always check 

the manufacturer’s instructions to make sure it is compatible 

with plastic. DO NOT use a cleaner if the label indicates 

it should not be used on plastics. DO NOT use spray-on 

cleaners that require daily use without immediately rinsing with 

water to stop the chemical cleaning reaction because damage 

will result and void the warranty.

Day-To-Day Cleanup

Clean your Swanstone vanity top with powdered abrasive 

cleaners. Use of a Scotch Brite pad is recommended to 

remove stubborn stains. Occasional use of a mild bleach and 

water solution ensures that the original luster is maintained.
Simply wipe the surfaces with a clean towel to remove 

watermarks and residues. All Swanstone products can be 

cleaned with warm water, a soft cloth, and normal household 

detergents or cleansers, such as Fantastic, Formula 409, 

Clorox Clean-up, Handy Andy, Mr. Clean, or Lestoil. Always 

rinse off cleaners within five minutes of application.
Occasional scrubbing with household abrasive cleaners 

ensures that the original luster is maintained.
For the most stubborn stains, fill the Swanstone vanity bowl 

about one-quarter full with a 50/50 solution of bleach and 

water. After ten or fifteen minutes of soaking, drain solution 

from the bowl as you wash and rinse both sides and bottom.

Note: 

Do not use steel wool or metal scourging pads

Cleaners designed to remove iron or rust should not harm 

Swanstone.
White automotive rubbing compound may be used to remove 

stubborn marks or discoloration.

Surface Repair

Light Scratches

Use 400 grit sandpaper to remove light scratches in the 

surface.

Deep Scratches or Gouges

For deeper scratches or gouges, use 220 or 320 grit 

sandpaper. A “Scotchbright pad” can be used to blend the 

repair into the surrounding area.

Swan 14 800-325-7008

Installation Procedure 

Maintenance and Cleaning

ADA-LB-002a

17” Minimum
25” Maximum

19” (48.5 cm)

MAX.

27”

 (68.6 cm) Minimum

34”

 (86.4 cm) maximum

ADA-LB-003a         

6” (15.2 cm)

9” (22.9 cm)

8” (20.3 cm)

IMPORTANT NOTICE