Installation Procedure
Disclaimer
m
The information contained in this Installation Manual is given
free of charge. It is based upon technical data which we
believe to be reliable and is intended for use, by persons
having knowledge of this technical area, at their own
discretion and risk. Swanstone assumes no responsibility
for results obtained or damage incurred from the use of this
material either in whole or in part by the buyer.
m
This manual will give you basic instructions for the
installation of the product in a step-by-step sequence that
will work in most types of installations. If you have an
installation application that is not covered in this manual,
please call your local Swanstone distributor or contact the
Swan Corporation directly for additional information about
your application.
m
Follow all installation instructions. Failure to follow these
instructions could result in personal injuries, water damage,
or other damage to floors, pipes, walls, or other portions of
your building or home.
Note:
Read All Instructions Before Beginning
Trial Fit
It may be necessary to trim the edge of the vanity top to fit
snugly against the side wall. Install the trimmed edge against
the wall.
Faucet Holes
Note
: All Swanstone sinks are manufactured with one
predrilled hole. Optional locations for additional
holes are located on the underside of the sink using
marks (4” and 8”) which are cast into the sink. Follow
Steps 6 and 7 for drilling additional holes to meet the
requirements of the sink faucet or other accessories.
1. If necessary, identify the location of additional holes for the
faucet or other accessories and drill a 1/4” pilot hole from
the back side of the sink.
To prevent damage to the unit, do not use an auger style drill
bit.
Breathing Hazard
When cutting or drilling the Swanstone
product, use a dust collection method
which prevents dust particles from going into the air. Always
work in a well-ventilated area. To keep the area well ventilated,
open windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
VI-001
0”
4”
8”
Swan
6 800-325-7008
Installation Procedure
VI-002
IMPORTANT NOTICE
VI-003
WARNING
Summary of Contents for Chesapeake CH1B-2225
Page 16: ...Swan 16 800 325 7008 ...
Page 17: ...800 325 7008 17 Swan ...