5.
Drill starter hole inside of cutout line.
6.
Use a saber saw to cut inside of cutout line.
D
Du
us
stt H
Ha
az
za
arrd
d
When sanding Swanstone product,
use a dust collection method which
prevents dust particles from going into the air. Always work
in a well-ventilated area. To keep the area well ventilated,
open windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swanstone products.
7.
Trial fit bowl and trim or sand as needed for proper fit.
8.
Clean bowl with denatured alcohol. Remove all dust and
let the surface dry completely.
S
So
ollv
ve
en
ntts
s H
Ha
az
za
arrd
d
Follow all manufacturers’
safety instructions for silicone
sealants and denatured alcohol. Alcohol vapors are both
flammable and hazardous to breathe. Silicone vapors may
irritate eyes and nose. Personal injury can result from
improperly handling or use of products, such as denatured
alcohol. Always follow the manufacturer’s
recommendations for the safe use of these products.
Ventilate any work area before beginning to apply silicone
sealants, cleaning agents, or solvents.
9.
If installing for raised mount, apply adhesive around base
flange and set bowl in place.
10. If installing for drop-in mount, apply adhesive on the
underside of bowl flange and set bowl into opening.
11. Install faucet per the manufacturer’s instructions.
12. Apply sealant to the bottom side of the sink ring
Note:
When installing the sink ring and tail pipe, use
plumber’s putty sparingly and do not allow it to contact
the plastic overflow assembly under the sink.
Apply Plumber’s
Putty
Here
VI-050
VI-033
Apply
Silicone
Here
VI-033
Apply
Silicone
Here
WARNING
WARNING
VI-031
VI-030
800-325-7008
11
The Swan Corporation – Swanstone
Installation Procedure
Summary of Contents for Chesapeake Vanity
Page 19: ......
