12. Apply sealant to the bottom side of the sink ring
Note:
When installing the sink ring and tail pipe, use
plumber’s putty sparingly and do not allow it to contact
the plastic overflow assembly under the sink.
To prevent breakage or distortion of the overflow assembly, do
not use oil-based caulking or plumber’s putty near the
overflow assembly. Oil-based plumber’s putty will have a
harmful effect on the plastic overflow assembly, resulting in a
leak. If a sealant is required between the overflow assembly
and the tail pipe, use a silicone sealant.
13. Install tail pipe onto the sink ring.
14. Tighten the tail pipe assembly onto the sink
Do not overtighten the nut when installing the tail pipe. Hand-
tighten the nut and then tighten NO MORE than one-half turn.
Overtightening will break the overflow assembly and void the
warranty.
15. Connect the faucet supply lines per the manufacturer’s
instructions.
16. Connect the drain lines and p-trap per the manufacturer’s
instructions.
17. Check for leaks.
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
IMPORTANT NOTICE
VI-052
VI-051
No Plumber’s
Putty in this
location
IMPORTANT NOTICE
Apply Plumber’s
Putty
Here
VI-050
The Swan Corporation – Swanstone
16
800-325-7008
Installation Procedure
Summary of Contents for Chesapeake Vanity
Page 19: ......
