Setting to the motion alarm
Setting to the ETC (Alarm Input method, RS-232).
Go to
SETUP
menu
(6.TECHNICAL SETTING
-
MOTION ALARM OUTPUT)
to do setting the motion
alarm.
Go to
SETUP
menu
(6.TECHNICAL SETTING
-
ETC.)
to do setting the alarm and RS-232 device.
Alarm(sensor) input method can be set either
NO(NORMAL
OPEN)
or
NC(NORMAL CLOSE)
in each channel.
NO(NORMAL OPEN)
sensor method normally keeps “
OFF
”
state and converts to “
ON
” state when sensor is detected.
NC(NORMAL CLOSE)
sensor method normally keeps “
ON
”
state and converts to “
OFF
” when sensor is detected.
Alarm output method can be set by
High
>>
Low
or
Low
>>
High
in each channel.
High
>>
Low
method converts output circuit from
ON
state
to
OFF
.
Low
>>
High
method converts output circuit from
OFF
state
to
ON
.
For more information related to RS-232 setting, see its
manufacture’s manual.
When motion is detected in each camera channel during
active time, alarm output device operates for alarm
duration time.
For motion alarm output setting, see “
6. TECHNICAL
SETTING - MOTION ALARM OUTPUT
”
Select
MOTION ALARM-ENABLE
in each camera
channel to use alarm output function and set alarm output
channel, duration and active schedule.
OPERA
TION
18
