The wires in the mains lead are coloured in accordance with the following code:
BLUE
NEUTRAL
BROWN
LIVE
GREEN/YELLOW
EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour markings identifying the terminals
on your plug, proceed as follows: The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L
or coloured red. The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with the letter E or
(earth symbol) and is coloured GREEN or GREEN/YELLOW.
WARNING: THIS APPLIANCE MUST BE EARTHED
Declaration of EC Conformity
BS Plug Wiring
Disposal of Unit
Disposal instructions for Swan items in accordance with the WEEE directive. Appliances
bearing the symbol shown here may not be disposed of in domestic rubbish. You are
required to dispose of old electrical and electronic appliances like this separately. Please
visit www.recyclemore.co.uk, or www.recylcenow.co.uk for access to information about
the recycling of electrical items. The WEEE directive, introduced in August 2006, states
that all electrical items must be recycled, rather than taken to landfill. Please arrange
to take this appliance to your local Civic Amenity site for recycling, once it has reached
the end of its life.
WEEE Directive
We Swan Products Ltd Declare that this product conforms to all the following
product legislation. In accordance with the following directive(s):
2004/108/EEC. The Electromagnetic Compatibility Directive
2006/95EC. The LVD directive (Low Voltage Directive)
2002/95/EC. The RoHS. Directive. (Restriction of Hazardous substances Directive)
Kev Stewart
Product Manager
wan
designed for life
This product is guaranteed for 2 years from the date of original purchase. If any defect arises due
to faulty materials of workmanship the faulty products must be returned to the place of purchase.
Refunds or replacement is at the discretion of the store.
The following conditions apply:
The product must be returned to the retailer with proof of purchase.
The product must be installed and used in accordance with the instructions contained in this
instruction guide. It must be used only for domestic purposes. It does not cover wear and tear,
damage, misuse or consumable parts. Swan Products Ltd has limited liability for incidental or
consequential loss or damage.This guarantee is valid in the UK and Eire Only.
Two Year Warranty
Cleaning and Maintainance
AFTER IRONING
Before cleaning, disconnect the power outlet and let the appliance cool down FULLY.
1. Wipe flakes and any other deposits on the soleplate with a damp cloth or a non-abrasive (liquid)
cleaner. NOTE: Do not use chemical, steel, wooden or abrasive cleaners to scrape the soleplate.
2. Clean the upper part of iron and thermal insulating cushion with a soft damp cloth. Dry
thoroughly
3. To remove the mineral deposits collecting inside the steam generator, firstly put the iron
horizontally on a level surface, then tilt the steam generator and unscrew the drain water cap with
the attached screwer, and then drain the steam generator.
WARNING: To avoid a risk of scald, make sure the steam generator has cooled down completely
before unscrewing the drain water cap.
4. After draining, screw the drain water cap tight and put the steam generator right way up again
.
5. If you don’t plan to use the steam generator for a long time, pour out the water in the tank, and
store the iron on the thermal insulating cushion.
6. Wind the steam supply hose and power cord around the cord winding groove and secure it by
the cord clamps.
DESCALING
To clear the iron of limescale build up put 2 x tablespoons (50ml) of vinegar into 1 litre of water.
Mix thoroughly and add to the water tank. Operate the steam function of the iron for about 10
minutes (don’t iron garments) to clear limescale buid-up from internal components.
After descaling, empty the tank and rinse out. Drain any water from the base as directed above.
SI4060N.indd 8-9
10/01/2013 17:48
