GB
14
Transport
Before handing, moving or transporting the
splitter make sure to cut the power off (unplug
the machine).
This machine is conceived for very ergonomic
easy handing thanks to the special wheel
arrangement in the rear bottom part of the
machine.
Before handing the machine around, make
sure to tie up the two control handles together
to prevent them from swinging out and
accidentally injure/damage persons or other
equipment standing nearby.
One man can easily handle the machine on
side by himself.
Handing asset is leaned back on the wheel
while the operator firmly holds it with one hand
on the handle of cover plate and the other
hand on the cover plate above the motor.
To prevent hydraulic oil leakage, never
transport the splitter laid down.
Always let the splitting knife go absolutely
down for transport.
Maintenance
Replacing hydraulic oil
Replace the hydraulic oil in the log splitter after
every 150 hours of use. Take following steps
to replace it.
1. Make sure all moving parts stops and the
log splitter is unplugged.
2. Unscrew oil drain bolt(35) which is location
on the bottom tank side , to remove it.
3. Push the log splitter, when the splitter
column (6) is in an inserted position. You
can drain the hydraulic oil off.
4. Clean the oil drain bolt
5. Screw oil drain bolt (35) . Make sure they
are tightened to avoid leakage
6. open the oil input plug(9) with dipstick
7. Refill fresh hydraulic oil at the volume as
per the hydraulic oil capacity of a particular
model indicated in the specifications table.
8. Clean the surface of Dipstick on oil input
plug and put it back into the oil tank.
9. Make sure the level of the refilled oil is just
between 2 grooves around the dipstick.
10. screw oil input plug
Periodically check oil level to ensure it is
between 2 grooves around the dipstick.
