Section II: Installation
2.0.INS.SL-214
CONTROLS INSTALLATION – MANUAL
1. Attach the valve mount bracket (
Pt.
No. 10H51
) to the main frame as
indicated on
Pg. 5-11
with the
fasteners provided (see
Pg. 5-7
).
2. Mount the hydraulic control valve
assembly (
Pt. No. 21P32
) to the valve
mount bracket as shown on
Pg. 5-11
with the fasteners provided.
3. Install the hydraulic adapters, connect
the hydraulic tubing & hoses (
Pt. Nos.
12P53, 12P59, & 13P12
) to the
control valve assembly as indicated
on
Pg. 5-9.
The tubing should be
supported by the clamp assemblies
that are provided in the Loose Parts
Box (see
Pg. 5-7
).
4. Determine the best location in the cab
for the control levers (
Pt. No. 20P08
).
The location should be such that the
controls can be easily reached while
operating the truck. A control lever
console (
Pt. No. 20P09
) is provided to
facilitate the mounting of the control
levers
(see Pg. 5-11)
.
5. Assemble and install the control lever
console (see
Fig. F
). Typically, the
console is fastened to the floor of the
cab and the control cables are routed
through additional holes drilled in the
floor. Your installation may require
that additional brackets be fabricated,
or other modifications made.
6. Attach the control cables to the
control levers and route the cable
through the holes in the cab. Install
the control levers in the console. Levers should be installed such that when the levers are
pushed forward the control cable is extended. See
Pg. 5-11
(Manual Control Assembly) for
control lever orientation.
7. Route the cables to the control valve location and attach them to the control valve with the
bonnet connection kits provided (
Pt. No. 20P10
). See the following instruction sheet for
installation procedures. The control cables supplied are 84 inches long. Your mounting
may require different length control cables, which can be purchased locally or through
SwapLoader. Take proper care when routing the control cables, as a good cable path is
essential for a proper operating system. Keep bends in the cable path to a minimum and be
as generous as possible. Under no circumstances should any bend be tighter than an 8"
Figure F
2-4
Summary of Contents for SL-214
